Hold the strings together and tie a knot at one end. This will be the first link in our chain, and you can see i. Bend the collar side downward using the key.
Put The Top String Down Through The Bottom Hole And.
Then use the back of the key to continue bending it down against the side of the tab. Polwig's tutorial however advocates the use of paper punches. Bend the collar down from the top side of the tab using the tumbler side of the key.
Place It Lengthwise To Look Like A Number 8.
You will need to prepare the tabs for the weaving. Next,take a nother tab and do the same as in step 1, then look at step 3.:) take the ends of the laces and pull them through the last tab,like on the pic. Snip one end of the pop tab.
You Will Need To Repeat These Steps 2 Or 3 Times For A Good Coating.
This is the starting point of your bracelet, so make the knot nice and tight. Follow along with the video and learn how to make a bracelet from soda tabs. Thread the cord up from the bottom through both tabs, bringing top cord through top hole and bottom cord through bottom hole.
Now Let's Get Started By Breaking Off The Rivet Mounts For Each Of The Tabs We Want To Use, Then Stack Five Of Them Together So They're All Aligned.
String the cord through the tab by pulling one end down through the top hole and the other end down through the bottom hole. Be very careful, it will be hot! Repeat steps 2 and 3 till the bracelet fits.
