Lay one end of the necklace or bracelet pointing down, and the other end pointing up. Bend the tip and bring it back along the outside of the loop. 3.then feed the end through the loop to create an overhand knot.
You Can Trim This Off At The End When The Project Is Finished.
Holding the knot cord about 1 to 2 inches from the end, make a loop. Keep in mind that if you’re doing a necklace, you’ll need enough to go around your head and a little extra for the knots themselves. Repeat steps 2 to 7 to form a second knot.
The bracelet pictured with the lime green cord is made with a single strand of 1mm cord, but i also show you how to make. Pull both ends of the 10cm waxed cord to. I always think the ends look like the ears of a bunny rabbit!
An Alternative To A Necklace Chain Or A Chain Bracelet Is A Simple Tied Cord.
Do not cut this half) Set up the end strands. Cut the length of cord you need for your project.
Make Sure To Wrap Two Cords And Not 1.
To form a second knot, repeat. Continue to bend at the beginning, passing the end of the working cord through the wrapping. Pull the end of the working cord to tighten it.
